Call for industry to support common alloy for beverage can body and ends

The beverage can industry needs to support the development of a new aluminium alloy that would better support recycling efforts.

Huang Ruiyin, chief researcher at Chinalco Materials Application Research Institute, based in Beijing, said work was under way to develop a new alloy for beverage ends that was part of the “greenization” of the industry in China.

He said: “Designing a new alloy with a composition roughly equivalent to that of the can body would maintain good service performance, and satisfy recycling requirements, and achieve a lower overall societal cost than the 5182 alloy.”

The 5182 alloy used for beverage ends has a different performance from the 3104 alloy commonly used for can bodies. Research into a design that uses a common 3104-type alloy for the whole can would simplify the circular recycling process.

“Therefore, the industry chain needs to jointly promote the uni alloy,” said Huang.

Market demand is continuing to grow in China, said Ruiyin. He said global consumption of aluminium can stock “exceeded” 8 million tonnes in 2025, with demand for can body stock at 6m tonnes and ends and pull tabs at around 2m tonnes.

Last year China produced 2.4m tonnes of aluminium alloy for the beverage can industry, with domestic consumption driving about half of that figure at 800,000 tonnes for body stock and 400,000 tonnes for ends in 2025.

The country manufactured 75 billion cans and 150bn ends to meet demand.

One of the options being considered for a new alloy was increasing the ratio of scrap content because the energy consumption and the carbon footprint was only 5% of primary aluminium ingots, he explained. However, Huang pointed out that this meant the alloy would have to be designed with a “higher impurity tolerance” and required “strict melt-quality control, and pre-treatment plus two-chamber furnace technology development”.

Higher scrap content also increased iron (Fe) content. Huang said: “The ratios of Fe, Mn (magnesium) and Si significantly influence second-phase formation. The final composition should maximize the α-phase fraction to facilitate second-phase fragmentation.”

Huang added: “Scrap is melted in dual-chamber furnaces, bringing oxidation loss down below 1%.”

Slag and hydrogen content was also limited during processing, including inline degassing and inline filtration.

The major canstock producers in China are Chinalco, Nanshan, Zhongfu, Xiangyu, Hongfa and Yongjie. He said; “Aluminium processors producing can stock in China are generally equipped with advanced melting-casting facilities and technologies to guarantee high melt quality, together with capabilities for scrap recycling.

On the hot rolling lines, thickness tolerance for 5182 is within ±20 μm and for 3104 within ±10 μm, he said.

“Automatic temperature‑control systems keep coil‑wide temperature variation within ±10 deg C under stable rolling. Some mills are fitted with online surface-inspection systems for real‑time surface-quality monitoring,” he added.

On cold-rolling lines, mass-flow thickness control keeps deviation within ±3 μm, according to Huang.

He said starting gauges had dropped to 0.240mm, but that export-grade products reached 0.235mm.

He suggested an improvement in can design and said that with better melt quality, improved thickness tolerance and strip profile, this would reduce earing [in the cupping operation]. “Secondary forming on can bottoms creates reinforcing ribs to enable thickness reduction.”

Gauges for beverage ends had reached 0.208mm, but that “some products reach 0.203mm”.

He said a revised end profile design could enable gauge reduction and said that after baking, yield strength reached 330-360 MPa.

He said this results in: “Improved strength retention after baking” and that it would reduce “pressure-resistance degradation.”

Huang concluded by saying: “Due to aluminium’s excellent sealing properties, high thermal conductivity, and infinite recyclability, it has strong competitive advantages in metal packaging and promising development prospects. 

“We hope that upstream and downstream enterprises will work together to continuously advance aluminium packaging toward lightweighting and green development.”

Related Content

Recent Articles